1.概述：

　　HC型系列有機氣體催化裝置是本公司多年研究、實踐、完善的成果。目前，第六代產品已被國內外用戶廣泛地使用，取得了顯著的環境效益、經濟效益和社會效益。該產品采用了IEC—439國際標準生產。該產品以優良的性能、可靠的質量，獲得了眾多的殊榮，深受新老用戶的一致好評。

2.產品結構特點：

　　HC型系列產品設計獨特，布局合理、被廣大用戶和專家總結出以下特點： 
2．1　操作方便：設備工作時，實現自動控制。
2．2　能耗低：設備啟動，僅需15～30分鐘升溫至起燃溫度，耗能僅為風機功率，濃度較低時自動補償。
2．3　安全可靠：設備配有阻火除塵系統、防爆泄壓系統、超溫報警系統及先進自控系統。
2．4　阻力小，凈化率高：采用當今先進的貴金屬鈀、鉑浸漬的蜂窩狀陶瓷載體催化劑，比表面積大。
2．5　余熱可回用：余熱可返回烘道，降低原烘道中消耗功率；也可作其它方面的熱源。
2．6　占地面積?。簝H為同行業同類產品的70%~80%，且設備基礎無特殊要求。
2．7　使用壽命長：催化劑一般8000小時更換，并且載體可再生。
3.設備應用范圍
3．1　可用于有機溶劑的凈化處理（苯、醇、酮、醛、酯、酚、醚、烷等混合有機廢氣）。
3．2　適用于電線、電纜、漆包線、機械、電機、化工、儀表、汽車、自行車、摩托車、發動機、磁帶、塑料、家用電器等行業的有機廢氣凈化。
3．3　可用于各種烘道、印鐵制罐、表面噴涂、印刷油墨、電機絕緣處理、皮鞋粘膠等烘干流水線，凈化各工序產生的有機廢氣。
4.工藝流程示意圖：
本裝置是利用催化劑做中間體，使有機氣體在較低的溫度下，變成無害的水和二氧化碳。  
CnHm＋(n＋m/4)O2  Pd·Pt/250~300℃ nCO2+ m/2H2O+熱量

5.選型及注意事項：
5．1　廢氣成分中，不含下列物質：
有高粘性的油脂類。 
磷、鉍、砷、銻、汞、鉛、錫。 
高濃度的粉塵

5．2　設備選型時，請注明廢氣成份、濃度及出口溫度。
5．3　設備安裝場所無腐蝕性氣體，并有良好的防雨措施。
5．4　設備所需電源為：三相交流380V，頻率50HZ。

1. overview:

HC series of organic gas catalytic devices are the research, practice and perfect results of our company for many years. At present, the sixth generation of products have been widely used by domestic and foreign users, and have achieved remarkable environmental, economic and social benefits. The product uses IEC - 439 international standard production. With excellent performance and reliable quality, the product has won numerous honors and is well received by the new and old users.

2. the characteristics of the product structure:

HC series product design is unique, the layout is reasonable, the following characteristics are summed up by the users and experts.

The 2.1 operation is convenient: when the equipment works, automatic control is realized.

2.2 low energy consumption: equipment starting, only 15~30 minutes to rise to the ignition temperature, energy consumption is only the fan power, the low concentration of automatic compensation.

2.3 safe and reliable: the equipment is equipped with fire and dust removal system, explosion-proof pressure relief system, overtemperature alarm system and advanced automatic control system.

The 2.4 resistance is small and the purification rate is high: the honeycomb ceramic carrier catalyst impregnated with palladium and platinum, which is advanced today, has a large specific surface area.

2.5 waste heat can be used back: waste heat can return to the drying Road, reduce the power consumption in the original drying Road, and can also be used as a heat source in other aspects.

2.6 small area: only 70%~80% of the same kind of product in the same industry, and there is no special requirement for the equipment base.

2.7 long service life: the catalyst is usually replaced for 8000 hours, and the carrier is renewable.

3. equipment application scope

3.1 can be used for the purification of organic solvents (benzene, alcohols, ketones, aldehydes, esters, phenols, ethers, alkanes and other mixed organic waste gases).

3.2, it is suitable for purification of organic waste gas in wire, cable, enameled wire, machinery, motor, chemical industry, instrument, automobile, bicycle, motorcycle, engine, tape, plastic, household appliances and so on.

3.3 can be used for a variety of oven, tin, surface coating, printing ink, leather processing, motor insulation such as glue drying line, organic waste gas purification process produced.

4. schematic diagram of process flow:

This device uses a catalyst as an intermediate to make organic gases into harmless water and carbon dioxide at a lower temperature.

CnHm (Nm/4) O2 Pd Pt/250~300 C nCO2+ m/2H2O+ heat

5. selection and attention:

5.1 of the components of the exhaust gas, the following substances are not included:

There are high sticky oils.

Phosphorus, bismuth, arsenic, antimony, mercury, lead, tin.

High concentration of dust

5.2 when selecting equipment, please indicate the composition, concentration and outlet temperature of the exhaust gas.

5.3 equipment installation site without corrosive gas, and good rain prevention measures.

5.4 equipment needs power supply: three-phase AC 380V, frequency 50HZ.